OEM Security Gate Security Scanner Gate For Public Entrance
Operation instructions
1, Open the disinfectant storage cabinet, put the disinfectant with good proportion into the storage cabinet and connect the pipe diameter
2, Connect the power supply
3, Start in turn 1.Ultrasonic spray disinfection 2.Ozone disinfection 3.Start button and equipment of blue light can operate normally
4, Turn off: turn off in turn
1.Ultrasonic spray disinfection 2.Ozone disinfection 3.Start button of blue light lamp, the equipment can be closed, and the temperature measurement system can be started automatically 5, Make up water: add disinfectant mixture according to consumption to ensure the certain atomization water level
Explanation principle
Triple disinfection with ultraviolet, plasma and lightwave atomization, matrix type dead angle free whole-body disinfection, non-contact disinfection, and more thorough disinfection the control cabinet has three keys, 1 in turn, 2 for ultrasonic spray disinfection, 3 for UV sterilization, and2 for the blue light start button. Ready for normal operation
After the disinfection lamp button is turned on, the ultraviolet disinfection on both sides and the plasma disinfection on the tap is turned on
After the disinfection key is turned on, the light wave atomization is turned on, which is divided into low gear and high gear. Shenzhen Anxia Technology Co., Ltd. is a turnstile gate manufacturers.
Scope of application
1, Hotel and catering industry
2, School entrance
3, Company entrance
4, Food industry
5, Electronics industry
induction spray
Ceiling ozone disinfection
Blue light display
Disinfectant storage cabinet
Non-slip Water Mat
6, Textile industry
7, Industries with special disinfection requirements, etc
Common faults of machine and troubleshooting
Fault phenomenon Reason Elimination method
The power switch does not work A: Power without electricity
B: Power switch not on
A: Check the power supply circuit to ensure normal power supply
B: Turn on the power switch
No spray after starting A: No water in water supply pipe
B: Water inlet valve damaged
C: Fuse bum out
A: Check the water supply pipeline to ensure normal power supply
B: Replace the water inlet valve
C: Replace the fuse of the same specification
Lessor no fog A: Excessive scale in the water tank
B: Aging of atomizing sheet
C: Loss of voltage
A: Clean water tank and atomizing
sheet
B: Replace the atomizing sheet
C: Maintain normal voltage
click to visit our website.
